support and development board for the MultiDisplay project.

Support in english
3 posts Page 1 of 1
I cannot get the application editor to show just a simple scematic that is not all broken up. I am having a problem trying to place the resistors on the md 1.3 sensor board I have because it does not match what is pictured online. Please any help would be greatly appreciated.
Shift+F3 gets you to the pcb view.

The picture in the wiki shows the first pcb version.
With what resistor do you have issues?
Hello, the Wiki pages are updated to the current PCB´s:
3 posts Page 1 of 1

Who is online

Users browsing this forum: No registered users and 1 guest