Page 2 of 11
AW: Spinoff, a small full PID Boost controller!
Posted: Tue 10. Jan 2012, 23:04
by bofh
Den Code check ich die Tage ein.
Re: Spinoff, a small full PID Boost controller!
Posted: Thu 12. Jan 2012, 06:51
by Metz
Klasse
Wie lang wirds ungefähr dauern bis es die Platinen ect zu kaufen gibt?
Dann hätt ich wieder was zu tun
Re: Spinoff, a small full PID Boost controller!
Posted: Wed 18. Jan 2012, 17:02
by designer2k2
das wird noch etwas dauern, aber Teile liegen schon alle hier!
Re: Spinoff, a small full PID Boost controller!
Posted: Sat 28. Jan 2012, 14:45
by designer2k2
Es geht weiter
Re: Spinoff, a small full PID Boost controller!
Posted: Sun 29. Jan 2012, 00:36
by Metz
Des sind viele kleine Bauteile?
Wieviele Lötpunkte sind des?
Für was gibts die RJ45?
Re: Spinoff, a small full PID Boost controller!
Posted: Sun 29. Jan 2012, 19:46
by designer2k2
Sind 53 Bauteile, nahezu alles SMD.
Und 212 Lötpunkte
Nicht RJ45, ist dieser hier:
http://at.mouser.com/ProductDetail/Mole ... SjVw%3d%3d
Da stecken alle Signale drauf, damit ist die Schaltung ganz einfach Ein/Aus zu bauen
Re: Spinoff, a small full PID Boost controller!
Posted: Mon 30. Jan 2012, 18:28
by Metz
Ach n Molex?
Sehr schön.
AW: Spinoff, a small full PID Boost controller!
Posted: Mon 6. Feb 2012, 20:04
by designer2k2
schon fast fertig
Mit Tapatalk geschrieben.
Re: Spinoff, a small full PID Boost controller!
Posted: Mon 6. Feb 2012, 20:58
by Metz
Re: Spinoff, a small full PID Boost controller!
Posted: Wed 8. Feb 2012, 00:07
by bofh
sehr schön.
werd mich dann Morgen noch mal ein bisschen mit der passenden Firmware beschäftigen.